Pile Cutter SHR
Previous | 1 / 2 | Next |
The SHR series hydraulic pile–cutters is design for cutting over-lengths of the foundation piles. The SHR series hydraulic pile-cutters are designed based on our experience in manufacturing hydraulic construction equipment. Our pile cutter products are designed:-
We designed the pile-cutter according to the variety size of the pile dimension.
Technical Specifications
- Clean cut of the concrete and without cut off the steel bar / re bar. The steel bar / re bar remaining inside the concrete pile.
- Fast cutting process by using 4 units of hydraulic cylinders to operate the cutter blades in opposite sites.
- For environmental friendly use i.e. with low noise level and no vibration.
- Low operation cost and high efficiency.
- Easy maintenance and don’t need special skills to operate.
- Can operate under water.
We designed the pile-cutter according to the variety size of the pile dimension.
Technical Specifications
Pile Cutter Series | Pile Dimension range mm (inch) | Pile Shape | Number of Re-bars |
SHR 1 | 100 – 200 (5 – 8) | Square | 4 |
SHR 2 | 200 – 250 (8 – 10) | Square | 4 |
SHR 3 | 250 – 320 (10 – 12) | Square | 4 |
SHR 4 | 300-350 (12 – 14) | Square | 4 |
Dimension of The Pile- Cutter
Dimension of the Pile- Cutter
Pile Cutter Series | A mm | B mm | C mm | D mm | E mm |
SHR 1 | 584 | 230 | 241 | 774 | 825 |
SHR 2 | 595 | 275 | 268 | 845 | 823 |
SHR 3 | 616 | 320 | 345 | 1152 | 1072 |
SHR 4 | 709 | 370 | 420 | 1362 | 1209 |
Note: The dimension is used for references, the final dimension may change to meet the site working condition.